🔋 Enhance Your Taranis X9D & X9d Plus with FrSky M9 Hall Sensor Gimbal Review

Excellent hangers. It's easy to install. Make sure you calibrate the sticks on your transmitter, then log into Betaflight and reset your mid and end points on your receiver(s).

Works great! I dropped my Taranis x9d+ se and it fell over. The pitch/roll stabilizer was not working properly so I bought one to replace. Perfect fit and exact replacement! Thanks very much!

Very good upgrade for the Taranis radio. I added these gimbals and a carbon shell that pretty much made the SE radio. I haven't upgraded the antenna since using Crossfire. One thing I noticed about the gimbal is that it doesn't stay all the way down in the down position. I like to use a small ratchet and tighten the friction washer, but it's still not ideal for ATV flying. I also think the price is a bit high.

Are These Stabilizers Better Than Standard Taranis Stabilizers? long shot! They're super smooth, that's for sure. They are also not that difficult to install. The main disadvantage of these gimbals is that the sticks are not the same as standard gimbals. So if you have fancy anodized embroidery ends like mine, they won't work anymore. Fortunately, the stick sticks on the M9 gimbal are quite handy.

Installation is easy. Just search for videos on YouTube. There are a few. Both hangers are the same and come with 5 screws. 4 to install each stabilizer. A stainless steel screw is used on the throttle hanger to loosen the centering spring, allowing you to adjust the throttle position up or down. The centering tension is adjusted with a 1.5 mm hexagonal screwdriver. Tools required: Phillips screwdriver. 1.5mm hex screwdriver and 2.5mm screwdriver. The final step is to calibrate the knobs and…