🔌 Effortless Connectivity: FS TFC Membrane Quick Connect Fittings Menbrane Review

Turned out exactly how it should have been. The thread cutting in the case is rubbish. The sewage port is by far the worst. I had to wrap about a quarter mile of thread tape around the fitting to make it feel like it could seal. Luckily it's not a pressure line (other than a check valve and flow restrictor), I'll find out how bad it is in the next few days when I can fit it. There is a possibility that I glue it together

This case is different from anything I've seen before. The outside diameter is smaller and the accessory clip I use for the final filter doesn't fit properly. Luckily I use a two stage system so I installed the clamps on a different case. The lid seal is also different. A seal is used, which is located on the housing neck. Previous units I've seen have a seal sitting on top. Nominally it appears to be in good condition and is not leaking. The included restrictive device was not required in my…

I had a 2018 single pass Hydrologic Stealth 300 which I used for maple syrup and ran juice , until the sugar content was reached 5-6%. It can take 12-16 hours for 60 gallons of juice. In 2019, twice as many trees were harvested and faster processing times were required, so the decision was made to add more reverse osmosis membranes in series to improve per-pass performance. I received 6 membranes and housings (I only received 2 housings from this seller as they had a limit, the rest I received…

My old 2012 (size not year) RO filter was clogged. Nobody could unscrew it to change the filter. What else can be done? Okay, buy a new housing, just put in a new filter and reconnect the lines. I'm flushing the system now. I'm seriously considering getting a new setup and adding this reverse osmosis filter as a final stage now that I have a working case that's unlocked. I think I'll go with 3 screw/unscrew stages and add this reverse osmosis filter and housing at the end of that line. This…

This case contains three connections for you to install. Two all white plugs and one white plug with a pink ring. There are no instructions in the box and the seller's answers in the questions are almost incomprehensible. Through trial and error and deciphering the seller's explanations, I came up with the following: White plugs: 1. A white plug goes into a detachable plug. This is the water inlet. In my system, the water supply line to the housing is yellow.2. The other white connection is for

I have a fairly old MultiPure RO drinking water system. The old reverse osmosis element body is stuck and cannot be opened as there is no convenient way to hold the smooth round body while removing the cover with a wrench. The only way out was to buy a new house. This case works great. It also has tabs to hold onto when attaching or removing the cover. I used a reverse osmosis element from Dow Filmtec https://smile.amazon.com/gp/product/B003LMFV7Q/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1