GemPro 2-Pack Smoked Amber LED Side Marker Turn Signal Light - Enhanced Compatibility with Golf4 MK4 GTI, R32, Jetta, Passat B5, Lupo, Polo, Sharan, Vento, Fox, Amarok, T5 Review

ordered these lights for my golf mk4. Installation was easy and looked good for months. They all recently stopped working together. I have all the fuses intact, I think the bulbs are dead. It is very difficult to remove the LEDs to replace them. upset

Works great and looks great! It was easy to install. The only criticisms are that they protrude a bit further than the factory, and the spring tongue is plastic and very hard. I'm afraid it might break if I try to remove it. Dynamic LEDs look great. I will update this review if I run into any problems later.

Very easy installation, took literally no more than 5 minutes. Go through the fender liner, take out the OEM side markers, unplug, plug in the new connector and put the side marker back in! The only complaint I have and don't even care is that the side markers protrude about 1/4"-1/2" out of the fender. They don't sit flush like the OEM side markers. However I love LEDs and although they are dimmed they are actually very bright. 10/10 recommend.

They were easy to fit, just be sure to use a cloth and a flat head when removing the stock turn signals to avoid scratching the paintwork. There are only two downsides to this product. Firstly they are a cheap plastic construction, they will snap into your car and stay strong but I'm pretty sure they will break if removed. The second one is preferable, they stick out more than the standard turn signals, which doesn't bother me, but if you think it bothers you, then here are your heads. All in…

Love how these headlights look on my 2001 Golf. I like the dark look and the fact that the light is different than anything I've seen before. CAUTION during installation. Since I didn't have original headlights before soldering the cables, I had to strip and connect new headlights. When stripping new wires, one of the wires broke inside. I had to cut open the plastic case, solder new wires to the board and reassemble everything. Definitely Frankenstein's work, but the light works perfectly. Be…

These sequential LED side turn signals look great on my DBP R32. Make it a bit modern. Also good quality. I've had them for less than 2 weeks and will let you know if I have any problems. Update: The passenger side mark has started to form condensation and I never wash my car. So not a very good seal for these LED lights. I decided to remove and remove the new side marker for inspection! The plastic clip holding the lantern to the wing is broken. (OEM side markers come with a non-braking metal…

Now you cannot upload a photo or video. But I just installed them on my MK4 GTI 337. The plastic plug with wires that goes into the lamp socket is a bit thick. They're tricky to connect, but that just means they shouldn't fall apart once the headlights are on the fenders. I have a setup so that the headlights shine from front to back. And if you're very picky like me, there's a left and a right. Both sides have fixed pins facing the front of the vehicle with a flexible lip on the side of the…