Genmitsu Standard Downcut Cutting Diameter Review

I had high hopes for this router bit but it fell short in every way.Thanks to my knowledge gained in practice, I can confidently say that this bit is not worth the investment. The cut was rough and the EDGES were jagged, leaving much to be desired. The one positive aspect was the durability, as it didnt show much wear after extended use. However, this was not enough to outweigh the poor performance..

I purchased these downcut router bits for a project and was impressed with the clean and smooth cuts they produced. My analysis of this product showed that they are made of high-quality materials and are perfect for industrial and scientific use... The only drawback was that they are a bit pricey compared to other brands, but they are definitely worth the investment for their excellent finish and durability..

A very good set of end mills and this is a very good set too. 1/8" and 1/4" straight and reverse cut router bits (4 total) and 1/4" single flute end mill for plastic, acrylic etc all.