🔧 GlowShift Fuel Pressure Banjo Bolt Sensor Thread Adapter for 24-Valve 5.9L Dodge Ram 2500 3500 Cummins Diesel 1998.5-2007.5 - Easy Installation on Fuel Filter Housing - Includes Crush Washers Review

Fits some Cummins 24v applications but the description doesn't say that it's not 14mm if you have a medium duty truck A 24v motor requires 14mm, the same as pre 98 Cummins pumps or a factory pump P. Now I buy the correct 14mm from GlowShift, i just want to list the thread size not the cummins model.

Although not listed in the description, this was the correct size for a '93 Dodge Ram 250 5.9 Cummins on top of the fuel filter/water separator. These are 12mm x 1.5 male and 1/8" NPT female. Nice that washers are included. Great for adding a fuel gauge to my truck. Torque as instructed to a maximum of 18 ft-lbs. so you can use it don't break it in half like some people do.

Nice zinc finish and no burrs. The quality is good, the threads seem to be correct. Haven't installed it yet, but my 1/8-27 NPT faucet threads nicely into the female side. I haven't tested the 12 x 1.5mm pin side, but I hope that's correct too. Update: All good!

I bought this to test the fuel system on Cummins industrial engines. It is ideal for connection to ISB/ISC fuel lines to check fuel pressure/restriction before and after fuel filters and booster pumps. However, it will work for connection to any system with an M12x1.5 banjo fitting. I use a 1/8" NPT Compucheck fitting which I then attach a gauge/gauge to.

Installing the glowshift fuel gauge is a mystery and you can't even see the picture on the cover. I order a Glowshift recommended damper valve, only to find that I also need a banjo bolt to thread in the damper valve. Received the order on time but need a return as the length of the banjo bolt, damper valve and sender block is too long to fit into the bottom of the fuel filter housing due to the motor mount. the person who wants all the puzzle pieces in one box. I've been working on this fuel…