🔌 GooDeal 4pcs Ignition Coil Connector Plug Harness 90980-11885 for Toyota Lexus - 4-Way Female Review

I did not use the power cords that came with it. Reuse existing ones on my truck. The included cables allow you to practice removing the installed plugs. Fits my 2004 Toyota Highlander Base 2.4.

Product worked PERFECTLY! I didn't use the wires that came with the plastic connector, I removed them and just used the plastic connector. It took me about 5 minutes to pull out the new wires and plug the old wires into the new plastic connector.

nothing more. weatherproof connections. good strong clips. Good wire length, easy to strip and doesn't lose a single strand from the inside. soldered a 16 gauge wire to the megasquirt. Works flawlessly. The only downside is that the clips are too tight. I'd rather do a little work on removing them than let them come loose on their own.

They worked for my 2008 Toyota Sienna V6. All three of my connectors on the front of the engine were cracked and brittle. I managed to pry out the white piece of plastic inside, then used a small screwdriver to remove each connector. I did the same for the ones on the minivan, the plugs from the car fit into the new housing with no problems.

Similar to the previous review I just used the connector/clamp and didn't have to cut/splice the wires. Followed the steps from the review and it was pretty easy. You basically remove the white plastic piece to access the wire retention clips that hold the end of the wires to the connector. Use a small flat head screwdriver to press down on the retaining clips to remove the wires. Follow the same steps to remove the connectors from the vehicle. Observe the correct cable sequence when removing…

The product works perfectly on my Camry 09. My connectors were old and broken when I wanted to change my spark plugs so I decided to get them as a replacement. Instead of splicing and replacing wires I just used the connectors themselves with existing wires and it worked great. All I did was gently pry the white connector with a small flat head screwdriver and then press down on the smart black tabs to release the included wires that went in wire order from the factory wiring harness. Pretty…

Good replacement for Toyota ignition coil connector. Original equipment ignition coil plugs on Toyota and Lexus become brittle over time. I bought these to replace my 2006 Toyota Camry. It's important to note that you don't have to use wires. I actually removed the wires from the connector housing and just plugged in my wires from Toyota. No cutting or soldering required. Here's how: 1) Get a set of jeweler's screwdrivers. 2) Carefully pry off the white pawl with a jeweler's screwdriver. It…