Header banner
Revain logoHome Page
hiletgo tpa3110 digital amplifier arduino logo

HiLetgo TPA3110 Digital Amplifier Arduino Review

2

·

Poor

Revainrating 2.5 out of 5  
Rating 
2.3
🚗 Car Electronics, 🚗 Car & Vehicle Electronics

View on AmazonView on ЯM

Media

(4)
img 1 attached to HiLetgo TPA3110 Digital Amplifier Arduino
img 2 attached to HiLetgo TPA3110 Digital Amplifier Arduino
img 3 attached to HiLetgo TPA3110 Digital Amplifier Arduino
img 4 attached to HiLetgo TPA3110 Digital Amplifier Arduino

Description of HiLetgo TPA3110 Digital Amplifier Arduino

TPA3110 PBTL Mono Digital Amplifier Board. Single-channel digital power amplifier Board PBTL. Amplifier Chip: TPA3110. Working voltage: DC 8~26V. Applicable Speaker Impedance: 8 ohm best.

Reviews

Global ratings 2
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Disappointing Performance from Digital Amp

This digital amplifier failed to meet my expectations for car electronics. While its compact size is a plus the sound quality is not up to par for driving in a vehicle. The low output power leaves much to be desired when it comes to powering car speakers .Unfortunately, I would not recommend this product for car and vehicle electronics..

Pros
  • Easy to use with Arduino and other microcontroller boards
Cons
  • Does not have built-in volume control

Revainrating 5 out of 5

I like these boards

I like these boards. So tiny, very little heat (usually 80-120 on an IC), no crackling and clear sound when properly powered. I'm using 12v 3amp and it works great with two boards powered by the same power supply. I don't get any hissing/hissing from the speakers. However, I have had noise with higher voltage laptop power supplies.

Pros
  • car electronics
Cons
  • periodicity