🔧 Hoover Wind Tunnel Replacement Belts - 13" and 15" Models - Pack of 3 Belts - Fits All Non-Self Propelled Machines Review

It's easy to think they're not long enough. They are long enough. The old belt just stretched. If you thread the new belt around the brush roll first and THEN the motor spindle, you can use some force to tighten the belt. Success! :) Pip

They fit my Hoover Pet Pro 3 wind tunnel although the part number was different. I dared and fit perfectly. They give a little and I'm grateful because compared to the size, the one that broke was a bit larger. Good quality. Good price for 3 tapes. Thank you!

Life saver! I was about to throw mine away assuming my vacuum was broken as the suction was very poor. Who would have thought that this little piece of rubber is essential for the roller brush and increases suction power. I really like that they include extras, a big plus and save a lot of money.

they broke after one or two vacuum cleaners I've had to replace one of the new belts. I need to get all the details and state that I also bought a replacement brush for my vacuum that may not fit and the belt could break if I try to turn it against friction. But compared to the old belt that had come loose from him. looked a bit thin.

I used to buy this type of belt at my local hardware store, only they didn't always have them in stock. I've bought this belt so many times. This is included in a pack of three. I used to use a belt every few weeks depending on how often we cleaned the house. It's been over a month and it's holding up great. It's a bit difficult to install due to the durable material, so I recommend it.

These might be the correct straps but installation is a little trickier than I expected. I called Hoover and a wonderful lady named Angel sent me instructions on how to attach the straps to avoid the almost instantaneous collapse I experienced. Here are the instructions from Hoover Customer Service. I will update my review after receiving the new belts and installing them according to these instructions: 1. Set the vacuum cleaner height adjustment to the minimum setting. Make sure the brush bar