🏞️ Hunter Chronicle 54-Inch Matte Black Industrial Ceiling Fan with Wall Control - Perfect for Indoor and Outdoor Use Review

Ordered this for a screened in porch we are in the process of building. We like the look of the fan, but are very disappointed that after installing the fan and wall switch, we found that the switch does not work at the lowest speed. Not wanting a two speed fan, I ordered a replacement Hunter wall switch. I expect better quality from Hunter.

CONTRADICTION TO DESCRIPTION, this fan cannot be flush mounted. The hunters themselves told me that for the "low” mounting of this fan, you need to cut the lower tube yourself and drill a hole for the pin. We already found out, but I asked them about a breach of warranty if we did the slicing job. A fan cools our approximately 500 square meter, screened terrace. feet

I bought a second unit to hopefully test and fix the problem with the first defective unit, yes both units are defective. The problem is with the bottom cover assembly, there is a large bottom piece that the bottom cover also screws onto. the supplied screws do not fit the pre-made nuts below, so the problem is either that the supplied screws are two widths, or the nut captured is defective or the wrong size, in any case it remains unfinished and that is seriously annoying. Hunter needs to see…

Nice fan. Remember that the fan hangs low. Has a 6" lower stem, although I believe it should be a 3". Only comes with a very cheap wall controller. The controller has a rotary knob without switching off. The controller uses a tilting plate. So if you want a decor style panel, you need to buy another dimmer switch for the fan. (Fan upgrade review. Had to replace the fan as the bearings in the motor were making a clicking noise. helped and sent a new fan. Had to remove the fan and replace the…

Many complain about the noise, not to mention the best part of this fan! Strength. If you max this villain out, the wind will literally blow in the room. That's great! And exaggerated in most situations. Keeping the fan on medium or medium speed will cause the ceiling fan to make a normal noise level. Still ok at full throttle. Yes, you can hear the fan running, but there's no metallic noise, clicking or anything else. This is the sound of air movement. And you can't calm it down I have two and

To assemble this fan I had to borrow a set of taps and dies from a neighbor because at least 6 out of 10 screws had snapped out of the threads. I have assembled and installed many ceiling fans and this was by far the worst build I have ever experienced. I've never seen so many bad screws in a ceiling fan assembly - ever. If the quality control of the motor is as bad as the bolts, I'm a little worried. I wish I could pay attention and notice that this is Made in China. I ordered a Hunter because