🦈 10 Packs of Shark Steam & Spray Mop S3101, S3250, S3251, SK410, SK435CO, SK460, SK141 Compatible Steam Mop Pads Review

I have an old Shark S3101 and the pads don't fit properly - I don't mind the fact that it's a bit bigger but its velcro straps don't fit like that I feel like that the handle of the steam cleaner is not the best. In general it works fine.

Sharks can be a bit more expensive so I decided to try these. For the money it's totally worth it. The downside is that they are slightly larger than the originals and thinner. However, they do; Holds up well and fits my Shark steam mop. It's also nice to have lots of mopping attachments on the back. Again they are great for the money and I would recommend anyone to buy them with this steam mop.

Using these nozzles instead of famous Shark brand steam mops leaves streaks on the floor. When I inspected the pad after use, I found that it wasn't thick enough and the whole pad didn't touch the floor when mopping, leaving the pad with dirt streaks and unused lines where it doesn't touch the floor. I finally found some branded replacement pads at Lowes. They are more expensive, but clean floors are worth paying for.

later Well it's been a long time since I got them but I finally used them on my old (very old) Euro Pro S3101 X (the last X might just be a logo, but he's sitting there on the Shark with Model No.). In any case, almost all gasket vendors claim their gaskets will fit almost all Shark steam cleaners. If you read customer reviews, you'll find that people are getting pads that don't fit their Shark model. Well they fit my model and I'm pretty sure they are as solid as the originals. I only cleaned…

If I could give this product zero stars, I would. The pads do not absorb dirty water. So you float the dirt and smear it all around you. I still have some of the original pads when I bought the Shark Mop and after a few minutes of steaming the original pads get dirty and wet. These new pads had almost no dirt and were barely damp from the steam. I steamed half of my white tiled kitchen floor with the original (but clean) underlay and the tile came out white. Then I steamed the other half with a