💡 iJDMTOY 36-Inch LED Ultra Slim Light Bar with Hood Scoop Mount for 2014-2021 Toyota Tundra, Includes (1) 108W High Power LED Lightbar, Hood Bulge Mounting Brackets & On/Off Switch Wiring Kit Review

I have a 2017 Toy Tundraw, as the instructions say, this product works. After I installed it as instructed, the mounting screws interfered with the top grille. On another pipe I found that I could drill another hole all the way to the bottom. The light wasn't long enough, leaving a gap in every streak of light. I'm disappointed. I really wanted it to work.

After installing this light cowl I encountered a big problem. At 105 km/h this tiny compartment gets so much air that it lifts the plastic strut and begins to flap. If you let go and look, the plastic strip on the truck's hood will break. I'm surprised others have reported this problem. This is a deal breaker for me because now I have to fit a special lens into the hood for it to work properly.

For the 2018 Tundra Grille, it is essential to fit the original honeycomb grille or trim that comes with your Tundra to give it an original look. I've watched all the videos available on youtube installing this light block and each person installs the light but doesn't put the plastic grill back on and that makes it look bad. because you can see the LED panel at a glance and it looks very secondary.

For the 2018 Tundra grille, it is important to install the original honeycomb grille or trim your Tundra to give it a standard look Person installs the light but does not reset the plastic grille and that makes it bad because you can see the led strip straight away and it looks very secondary.

Initially I was pleased with this lightbar but have had trouble fitting the hood bulge properly since installed it. To do this you will need to remove 2 of the 5 top clips that attach the grille to the truck. When I pick up speed these missing clips cause the hood bulge to loosen and last time 2 threaded insert clips (which actually secure the part to the truck) broke and now I have to buy a whole new hood bulge. I will remove this light bar to ensure the new grill part does not have this…

The only thing keeping this from a 5 star rating is the installation instructions/method. I first contacted the manufacturer and was assured that the rod would fit behind the screen in the hood. However, after the bar arrived I was told via email and several phone calls that this was not the case. Undaunted, I removed the screen insert and cut it out with a Dremel tool. After about an hour and a lot of careful cuts I was able to get to where it fits in front of the bar. The benefit is that you…