Ingersoll Rand EC400 NS Attachment Removes Review

Bought a 2003 Jeep Wrangler with quite a bit of rust underneath. I use this before using a rust converter to remove as much of the old stuff as possible. Works great, even with my 6 gallon pancake compressor. Saved a lot of time compared to trying to connect a wheel.

The fact is that I need to buy another product, but not too expensive - up to $ 50 - but I have an old model, but a very high quality "Welcome" model from the UK brand "Welcome" I think... It would be nice if they (head screw) were compatible with the needle scaler attachment shown above, but the threading or pitch is different; especially since the Wiggum model was produced for aircraft construction during the Second World War

Didn't read the fine print my fault but thought it was a little pin prick descaler but it's an air hammer attachment I was a bit disappointed but after I put it together with a new spare air hammer, I had a tool box I forgot and did some welds and then cleaned them up, I figured I like it a lot and I'll keep it and enjoy it because it's a damn one good tool is, thanks for a good product

I dig for metal a lot and sometimes bring cool iron stuff. They are always covered with rust and growths. This thing gets rid of rust quickly and is fun to use so it doesn't feel like a chore. It's heavy and will make your air chisel very heavy, but it's worth it. Attaching is easy, you simply loosen the three hex head screws on the current head and unscrew the main head. Then unscrew the needle head and screw in its hex head screws. I would absolutely recommend this. It's so cheap and adds so…