🌡️ Innovate Motorsports 3853 MTX Digital Series Water Temperature & Battery Voltage Gauge Kit Review

Easy and convenient way to control water temperature and voltage! Easy to install, but you need to weld a plug on the location of your choice or use 1/8 NPT thread adapter. It's easy to set up your perimeters when Logworks is activated! If you plan to monitor it, update it or change the perimeter via your laptop, leave the 'OUTPUT' cable available!

AWESOME sensor. LOVE dual functionality. For a small car, having more than one function set on the same sensor is SWEET. Installation was pretty easy and all my wires were the perfect length and had a bit of room to spare. I bought a Mishimoto coolant hose adapter, connected the sensor to the upper radiator hose (where the hot coolant exits the engine) and wired it through the firewall to a set of racks from Fap9tuning. I like the setup, definitely plan on getting an oil pressure/temp sensor…

this sensor has been installed and the water temp is working fine. However, the voltage sensor has no readings. The instructions on page 4 in section 2.2 item 3 state: "Coming out of the two-pin meter connector you will find a black wire with a stripped end. Connect this black wire to the same ground source as the meter." The extra black wire with the stripped end does not come out of the pin header. I have contacted support but no response. Will update review if this issue is ever resolved .