🔥 InRobert DIY Two Ball Bearing Cooling Fan for Zotac GTX 1060 Mini - Boost Video Card Performance Review

If you don't already know, the original fan of the zotac geforce gtx 1060 3GB is prone to failure and the cards will eventually fail quite early. fail. If you're lucky, this will happen while you're right there so you can feel the temperature rise and/or hear the horrible noise the factory fan makes when it fails. I was in the middle of the Heaven test with the maximum settings under heavy overclocking and the fan set to 100% manually. My card was used for about 6 months before it was given to…

Although it was much better than the failed standard fan (zotac 1060 mini) my 3 stars are mainly due to it needing to be replaced. Fit, wrong advertised fan speed (yes, 810,811 RPM is correct) and so-so performance (82C in-game) compared to a temporary solution for a 120mm case fan tied to a fan shroud. It's cheaper than a nice and quiet 120mm fan and obviously doesn't require a slot under the card, but in this case again I had to use a 120mm fan.

Perfection! Zotac should send this seller Christmas cards and give them market share. Let's face it, Zotac Mini fans are GARBAGE. These replacement parts are PERFECT! Be aware when purchasing this or this fan for the Zotac Mini 1060. You'll need to snap off the plastic wire guide (very easy to do and won't damage the wiring). Buy these! If you have a Zotac Mini 1060 and your fan is fine, BUY ONE ANYTIME. You will not regret it

My GPU is about 4-5 years old and recently I had problems with overheating. I also literally heard the GPU fan slide over the heatsink. Bought as a replacement and now everything works great again. A couple of issues: the cable routing was too long so I had to cut it off, and the fan connector cable itself was also a bit long. I just brought it outside of the GPU case instead of cutting and remounting it.