🚰 Enhance Your Water Quality with Instapure F2 CHROME CAP SYSTEM Faucet Filter System Review

Easy to install and filters water well. It doesn't put too much pressure on the faucet unless it's fully open. What I don't like is that it lasts a little over a year. Also, you should remember to change the filter because there is no other reminder than that the water may not taste good.

I was delighted to receive it in the mail but unfortunately I was unable to use it due to the unusual size of my faucet. So unfortunately I had to send it back, but you still get value for your money. But I have a setup on another floor in my house and it works great. I would be uncomfortable using water without a water filter.

The most compact and efficient faucet filtration system. I've been using them for many years and love the ease of installation and the quality of the filtered water. If you live in a hard water area, keep the chrome version clean with a sponge dampened with vinegar about every week. In addition, and by regularly replacing the filters, they last a long time.

I've been using Instapure since they first came out in the 1970's, always great clean water tastes great. They actually use activated charcoal for filtering, just like they used to. Local stores didn't sell them back then, except for a "clean" filter, which cost more than the housing and replacement filters (which ALWAYS clog after 2-3 weeks and slowly turn into a useless trickle). Finding her is a relief. available from Revain. They last me 3 months compared to some competitors from 3 weeks to

I've used one of these for decades. They used to be sold by WaterPik. It uses a replaceable activated carbon filter that removes most bad tastes like fluoride from the water. Current models are not built as well as older models. It uses a kind of metal pot instead of the old solid plastic models. My new one already has a small leak. Installation is easy and only takes about five minutes. All necessary tools and fixtures are included. I use it to filter water for my Keurig coffee maker.

It was great until I had to remove it and then reinstall it. I installed it with no problems. However, I removed it and when I attempted to reinstall it, the threads on the gray adapter failed to tighten. He continued turning without tightening. Every time I thought I had finally plugged the filter back in, it would fall off at the slightest pressure. When examining the housing, I noticed that the internal thread on the adapter had snapped off! I wish they would spend the extra dollar and make…

This entire unit is plastic including the adapters which failed in less than 4 months. Then the device kept falling and after doing my best to fix it, I decided to contact the online support team for assistance. Their online support insisted on a picture showing the problem and was generally useless. What did you want to see? The moment the device fell down? I then contacted them over the phone and was assisted by a very helpful customer service representative who sent me a new set of adapters.

Everything worked on installation until we had to replace the filter, after which the unit started leaking from the overflow hole at the bottom of the filter housing. Thinking the replacement filter was defective, I ordered another box and the result was the same. I returned both filter orders to Revain and ordered filters directly from Instapure. Same results. I pulled a video from Instapure and it showed a device with two white washers in a filter holster that weren't in my device. I have…