Juno Lighting Group ULL24 3000K 90 CRI White LED Under Cabinet Light Review

We have such a light in the pavilion. Whenever the temperature exceeds 80 degrees, the strip of light peels off, exposing the bulbs.

They are so thin that they are almost invisible under our cabinets, but at the same time they illuminate work areas well. I highly recommend it!

One of the few inexpensive cabinet lights that the manufacturer says can be mounted above a heat source (hob). The nice touch dimmer is part of the device, nothing extra to buy. Stay cool with LEDs to keep the bottom of the cabinets from getting hot.

Needed to replace a dead 60w xenon light and chose an LED which I hoped would match the color balance and light output of the original would that replaced them. The dimming feature was a bonus. My wife liked it so much that we replaced the other two xenon lights along with the first unit to improve the overall light quality in her main cooking area. And we've achieved energy savings of 10 to 1.

We bought this flashlight in March and we LOVE it. it was so easy to install and it works great. The light is very even and soft. And it's great that there's a dimmer - we use it all the time, especially at night. I can highly recommend this lamp. We use ours over the sink in the kitchen. We didn't need more than one so I can't vouch for how well it works with the others.

The only problem I had with the installation were the mounting screws. I only drilled the holes so the screws would pass freely and tighten the case. Then install 3/4" flush. Break the perforation forward and adjust the tip and your 2/3 Romex will fit snugly. Schematic. Truly a niche product. Couldn't find anyone during my research that does this.

Was impressed with the quality of light they put out. I connected them to a single wall switch to turn them on and off, but I LOVE that each individual light can be dimmed or turned off completely. We have been working for 7 years without any problems and failures. I connected my cable to the Juno Direct Connect Module, ULH-DWMWH and the Romex cable was routed over the edge of the wall/closet. However, I had to modify the module as the wire connector is not connected to the light bars as they…