PNT Paint Grade Plugs for Enhanced SEO Review

These are great pocket hole plugs, they fit very well and after sanding they look great... Only thing I wish they were in a bigger pack/bulk because I use them a lot and I want to instead many small boxes to buy a big box of it.

Craig never disappoints with his products. Used this with pine which I later painted. You could hardly see these traffic jams. The fit was snug enough to hold onto but not so tight that I had to hammer it in. A small amount of medium-grit sandpaper on pluggers will quickly clean them.

I used the KREG system to install railings at my camp. The screws held the components together very well. Attaching the corner caps was easy, but the fit was a bit sloppy with excess caps sticking out. However, we found that the excess was sanded off very well and the finished rig looks great.

Just like in the ad. I don't like that the tip sticks out a little bit from the hole. I'm new to pocket holes so maybe there's a reason? Not a big deal really, just take my handsaw and saw it off and then sand it down. Really useful, but you can get the same (if not better) result if you use a dowel. It's nice to be convinced.

These plugs are great for painting the finished product. However, it is not so good when using different types of wood, such as cherry or some rare woods. I made a mount to make my own corks from scrap wood I used for the project. However, I just saw a video of the Kreg connector that can be used with the Kreg J3, J4 and J5. Allows the user to make corks from any wood they want.

This is more expensive than just buying wooden dowels and using a flat saw. inch of plywood and figured it would save me the time of cutting out all the dowels. Unfortunately since it works with holes up to 1.5" it means they ended up being too long and I still had to cut each one with a saw. If you aren't using a 1.5" hole I would just buy dowels and save money.