🚗 WEIMELTOY 194 LED Car Bulbs with 3030 Chipset, 2-SMD T10 194 168 W5W LED Wedge Light Bulbs, 1.5W 12V for License Plate, Courtesy Step, Trunk Lamp, Clearance Lights - Pack of 20 Review

These lights are the perfect replacement for any 194 bulb. Polarity can be annoying, but it's worth it. In my photos, the one on the left is a standard 194 bulb, and the gauges on the right are the big difference between these LEDs! I put her in a heavy truck. My drivers love them and they love that they are dimmable

After 16 years of use, the old camper needed new headlights, hence the decision to switch to LED. Tried some others but the profiles weren't short enough; They were perfect - just remember to turn on the chaser when inserting the bulbs to check polarity. Perfect fit and bright.

Ok I've replaced every light with LEDs since they became a thing. These are without a doubt the best T-10 style LEDs I have ever used. The power spreads like a lightbulb. They are clean, we will build and are as perfect as can be expected. The output power is probably 60% higher than other LEDs I've had in the car.

I measured actual current at 13.12V and most of the 18 devices I tested drew only 0.044A, three devices at 0.043A and two at 0.046 A. That gives me about 0.6 watts actual rating. If you know this is NOT a 1.5w unit as advertised by the manufacturer you won't be disappointed. Durability and cost assessment? The time will show.

They've been in my car for a week now. Some of these are interior lights for my control center (engine service light etc) and none of them have deteriorated or are DOA. They seem to give a decent light for any indoor application and even some outdoor applications (parking lights etc) but don't expect them to act like fog lights or brake lights. They are not bright enough for that. They dim the lights on my 1987 Corvette correctly. Their build quality appears to be better than most.

194 LED bulbs 3030 - 20 out of 20 bulbs worked when arrived. not marked. My application was to replace the old conventional turn signal bulbs on the dashboard. In normal operation, these lamps do not light up. So I had to check each bulb and mark the B+ side of the bulb. This confirmed that the bulb was working and allowed me to plug it into the test light on the dashboard in the correct direction. It would be nice if the manufacturer marked the lamps with the B+ side, as they know this at the…

These bulbs work great! I run a fleet of about 15 small cars and some of them have up to 8,194 bulbs in their exterior lights. We often burned them. A while back I installed LEDs in a car and finally decided to rearrange all the cars. I like that they aren't too extreme as other lights I looked at were too bright for some of my applications or had too many LEDs as they would drown out other light sources. In any case, they are brighter than standard and do not jerk or flicker. Since they're…