Leviton 88016 2-Gang Duplex Receptacle 🔌 Wallplate, Standard Size, Thermoset, Device Mount, White Review

Fits well, looks good. The price was good. However, there are no screws for attaching to sockets. They should contain 2 screws. I still had to go to the hardware store.

These exhaust plates are made from a hard, brittle plastic that is not very flexible. You will break them if you tighten them more than a little.

For some ridiculous reason they don't sell them an hour from my house. I'm glad I found them at such a great price. Necessary hardware was included and the fit was good. No complaints

Will not fit 20 amp Eaton outlets. It was just too small to fit over it. I suspect a little Dremel work will fix this, but after finding the Eaton stainless steel wall plate to be a perfect fit I figured it would be easier to return it.

Nothing to say other than it's a very good product at a good price and looks great in the kitchen. It is covered with a blue plastic film to prevent scratches during transport. Removing the blue foil gives you a nice looking outlet or switch cover.

Product as advertised. It arrived damaged hence the four stars. Wasn't worth the time to return. Superglue was easier. I wouldn't put a hard plastic outlet cover in a plastic envelope without padding. Cardboard boxes can fall on the envelope and break everything inside.

Very nice polished nickel switch panel that goes perfectly with the nickel faucet, towel rail and toilet roll holder in my bathroom. An old, dull, off-white plastic cover will not improve the look of the room. That's how it is. Attention, when it arrives, it looks blue. You say "WTF" and want to start the return process. It's actually covered in a very thin layer of blue plastic. Take it off and voila!

These panels are designed to be placed at mattress height next to a cot where you can lay flat. Much stronger than the replacement plastic plate BUT much thinner so the bushings protrude from the plate by almost 1/8 inch. With a plastic top, the bins sit flush with the top, making them less prone to damage. Comes with a blue plastic sheet to protect the stainless steel cover; Don't forget to remove it before installing.

Lisa and Travis are the fifth star in this review. The wall paneling itself is fine. I think Leviton since they moved production out of the US their products seem to be made out of egg shells and not plastic. It fits perfectly but feels very cheap compared to the wall plate I got in the late 90's. The first order for the wall panel actually arrived with cracks in three places. Lisa emailed me before I contacted customer service and asked me to check the package to make sure everything was ok…

Very nice brushed nickel control panel, it goes perfectly with the nickel faucet, towel rail and toilet paper holder in my bathroom. An old, dull, off-white plastic cover will not improve the look of the room. That's how it is. Attention, when it arrives, it looks blue. You say "WTF" and want to start the return process. It's actually covered in a very thin layer of blue plastic. Take it off and voila!

These panels are designed for places - at mattress height next to a crib - where you can get laid flat. Much stronger than the replacement plastic plate BUT much thinner so the bushings protrude from the plate by almost 1/8 inch. With a plastic panel, the bushings are flush with the panel and are therefore less prone to damage. Comes with a blue plastic sheet to protect the stainless steel cover; Be sure to unplug it before installation.

Lisa and Travis are the fifth star in this review. The products are made from egg shells, not plastic. It fits perfectly but looks very cheap compared to the wall plate I made in the late 90's. Customer service told me to check the package and make sure everything is ok. When I told her it was damaged she just sent compensation without asking me anything else. Thanks again.