🔍 Enhanced Longer LCD Screen Smart Display Controller Board for Longer (Orange 10): Unleashing Advanced Visuals Review

Attention customers, I've ordered three of these and none of them work, even after a firmware update. The newer screens have a brighter dimming area, a printable area that shouldn't be printed, but this wasn't a problem with the older SLM4.5-5FPC-A LCD model. The shaded area was very dark and allowed normal printing. These newer LCD screens cannot do this properly, model FXD045FW11S-FPC-A1. I contacted Longer and received a firmware update but it didn't work properly and didn't fix the issue. I

I had to edit my original review. After everything finally went well with the installation, everything works perfectly. Furnished. This is useful information that has been overlooked. That's the end of the new LCD. I'll probably upgrade the rating if I get another LCD.

Came as promised (Take note more! Yours took 2 months). About AMAZON .2 DAYS. It's been installed for a month and so far so good.

I received a replacement LCD today, it seems to be defective. There is no visible damage to the LCD, maybe it's something else? Update: replacing it with this replacement does the same.

I don't know what happened in the last 4 months but it's not the same packaging experience as my last order. In the past, when you ordered a screen, there was a piece of foam in the box that held the screen in place. This time it was the same box but wrapped in bubble wrap. Sorry, it's an asterisk. I've also received pre-cut tape to attach the screen before, but not this time. I know it's not listed on the packaging, but they mention it in all the written and video instructions they post…

Just received an hour ago and finished installing. And as I feared, like everyone else, the screen doesn't work. Only about 1/3 lights up, the rest is dimmed. Very dissatisfied. It was packaged very well which leads me to believe these are just poor quality copies of the original. I'll go back and look for another source for a replacement.

The problem is most likely with the printer itself as there is no cooling or even ventilation to remove heat from the LED assembly and LCD. Crappy printer design even as cheap as it is.