🔧 Optimize your Sonar with Lowrance 000-12603-001 3D StructureScan Bracket for Enhanced 3D and Totalscan Transducers Review

Would have appreciated the 4 stainless steel washers that should have been included. I'm shopping at the hardware store.

Attaches to my kayak under the hull in a recess. The bracket that came with the Lowrance sonar was too large for the transducer. The old metal bracket was just what I needed.

Matches the general scan sensor very well and has worked flawlessly so far. Disappointed by the fact that it has already started to rust. Needs regular maintenance, 3 stars for that.

We were returning to the slipway and heard a knock at the stern of the boat. I immediately turned off the sensor and found that the cheap factory plastic mount had detached from the transducer and was dangling in the water. We temporarily tied him to the control cable to come back. He pulled out the boat (pontoon) and removed the cheap factory brace and replaced it with this stainless steel one. Very strong and should last forever. rest on the water.

The original plastic bracket broke because I had to trim it to fit the mirror. He didn't have much material left and I hit a sunken tree and it snapped off. I used a metal mount instead of plastic and it matched the old holes perfectly. I work in many areas where there are stumps and have not had a single problem. The plastic mount allows the transducer to rise when I'm running through the water at high speed. The metal bracket keeps the transducer in place even when working hard at high…