LUMITECO Locking Tire Chuck with Rubber Hose and Fine Thread Standard Valve, Tire Pump Hose Adapter for Twist On Conversion to Lock On Connection Review

Seems to go well with the EP Auto Compressor which I first used about 3 weeks ago. The second time I used this cartridge, it broke while I was inflating the tire. I found that some of the thin threads inside were snapped/torn off so I couldn't screw it back into the compressor port.

The air pump only came with a hose screwed onto the valve stem. Screwing it in and out was painful, the air would come out no matter how fast I unscrewed the hose. I found this air liner that easily attaches to the pump hose with a thin thread. The air cartridge is fixed and can be easily removed. It's so nice to be able to adjust tire pressure quickly and easily! The quality of the air cartridge is also excellent.

If your tire valve is on the bottom of the wheel or your wheels are small, you're good to go. However, if your tire valve is on a larger tire, e.g. an 18" tire, the extension is too short to reach, even when attached to a portable compressor hose. Buy the 23-inch version instead. It costs $3 more, but it's worth it as long as you don't mind holding the compressor in your hand for as long as it takes to fill a tire.

Air pump manufacturers don't seem to be the people who use them. These people are right. The connecting clamp is required for home use, not for professional use. It is great. Like they use pumps. It's very well done. Now we must force the pump manufacturers not to put an analog gauge on a pump that is too underpowered (which is fine on a dial reading 300psi on a pump that doesn't run at 60) and that the gauge is unreadable. it works at close range.

Stupid? Yes. In Florida gas stations charge air (I'm from California where it's illegal). So I'm worried about getting my tires pumped up before time runs out. Of course, this spoils everything and usually removes more air than I let in. I bought the air filler for my own use (without ridiculing an audience) and on the advice of "other" Amazons. also buy" got it. Neighbor showed me what it is and voila! I'm authorized. I've used it a few times and so far it's holding up very well.

I returned this item in hopes of using it to replace my straight clamp end gauge hose with a 90 degree hose but the threads were too small. In hindsight I found that the small threaded end fits into the straight clamp end of the existing hose. Although the hose can be used with my existing setup, the place I need to use it (the rear wheel of the bike) is too narrow to fit a 90 degree chuck on the valve when the locking lever is sticking up. Too bad for me, but not the fault of the hose and…

First. I had no problems with the delivery. The package arrived on time and in perfect condition. Secondly. The adapter fits my pump perfectly and makes the job easier. Good product. Third. I've learned that you shouldn't push the lever lock all the way onto the valve stem, because when the lever lock fully engages, you push the valve too far and the valve pin gets stuck and then you have an air leak. Not a big problem, but just FYI. Finally. Quality product and I strongly recommend it, not the