🔧 MAGBIT 704 1216 MAG704: A Multi-Faceted 4-Inch to 13-Inch Solution for Various Needs Review

The MAG704 industrial drill bit is a game-changer! After I put it to the test, I was impressed by its speed and accuracy in cutting through tough materials. Its 4-inch to 13-inch range is perfect for almost any job. The bit is well-built and feels sturdy in my hand. The only con is that it's a bit pricey compared to other industrial drill bits on the market.

Works great, drilled about 60 holes, cuts brand new. Same time I had a slight curve in the bit. I blame myself for using it at an angle above my head. Should have been my own fault because the middle of the bit is thin. But I think if you go straight, everything will be fine .

I used a bladed bit to drill holes in some landscaping logs and was only able to drill about an inch before I had to pull it out to clear the wood chips otherwise it will hang. I bought this piece and it's like piercing butter with a hot knife. I stacked them three high and ran rebar through them to anchor them to the ground. What difference does it make that the drill makes a difference compared to using a paddle drill for those deep holes. It's also very sharp and cuts very clean holes.