📐 Enhancing Education with Metric Stainless School Architect Engineers Review

I can't talk too much about precision as there may be variables I don't know about. But I have graphic design rulers that are not typewriter rulers that are set to zero. But when I line them up, compare them, they're pretty accurate. So that's good. Overall I think they are ok for what I will be using them for.

This is very bad. The ends of the ruler are not cut square (see photo) so they end +/- 1mm from zero with the ends cut at an angle. It looks like the rulers are cut end to end from printed pairs. It would be nice if they used a simple clip to cut them in the right place, at exactly the 90 degree angle. Instead, it seems like someone at the factory is thinking to each of them, "Uh, that looks right." Alternatively, they may measure carefully; but with other tools from Yipinve. you have been…

These are good light weight rulers. Hanging holes are good. They're 1.01 inches wide and 0.028 inches thick, making them a little bulkier than a machinist's scale, but better for general work and thin enough for accurate measurements. I'm fine judging by my calipers. The 1-inch width allows for large, easy-to-read numbers and tick marks. This was facilitated by the presence of inches on one side and centimeters on the other. This allows for larger numbers since you don't have to have two groups