🌬️ MICTUNING 52" Universal LED Light Bar Cover - Water-Resistant, Windproof, Dustproof, Snowproof & Scratch-Proof Protective Sleeve for Straight and Curved Bars Review

I tried another one made out of plastic with magnets to hold it in place. The glue will shift when hot. I thought I'd try. It was half the price of the competition so I wasn't expecting much. However, it's made from the finest materials with a soft inner lining so it won't chafe your gear. The Velcro is well stitched and runs from one end to the other. All I had to do was cut slits on each end to bypass the attachment points. I've had it for a few months and it's weatherproof and holds up well…

This cover will definitely protect your lightbar from the sun and keep it safe on the go. What I don't like is that it's a "project" to turn on and off! You should be able to reach the full length of the light bar to get this thing on and off, which means you'll probably need a ladder, like I did with the A-pillar bar. My concern is that dirt or sand will get into the soft liner and act as an abrasive pad on the lens and do more harm than good, I'll keep an eye on that. The lid is cheap, does…

I haven't had any major issues with this case. I only turned it on fully once (to check my car) and it did what I needed, well enough. However, I would like to point out a few things to keep in mind: First, it's an absolute bear to wear. Since I was alone, I had to take the roof off and climb into the front seats. It made things easier, but it was still difficult. Just the type of design. The velcro that holds it in place is SUPER strong - once you install it, it won't fall off, which is a good