Enhanced Mikuni Lever to Cable Choke Conversion Kit Review

This is exactly what I needed to fix a stuck carburetor piston. I had to drill out the existing one because it was stuck in the carburetor casting. The parts are fully matched at the factory. I noticed that the adjusting nut on the new parts is a bit shorter than the factory nut.

Once again, Mikuni grabbed my short hair! I just had to change the spring. The original rusted on a three year old very clean Yamaha bike! Too expensive and there must be a way to get the parts you need without buying complete assemblies. The rubber part also cannot be used due to the difference with the Yamaha part.

Piston only works for Honda Rebel All other components are unusable. but since I only needed the plunger tip to replace the one that broke in the carburetor space, I don't mind. much cheaper than what Honda wanted for the piston or the enrichment valve as they call it. However, if you also need a plastic fitting for Honda Rebel, this brass fitting is too small in diameter.