💪 Maximizing Efficiency: Unleash the Power of Milton Industries HIGHFLOWPRO Interchange Application Review

At first I thought it was all advertising but when I got it I changed my mind. Their inner diameter is absolutely huge compared to anything else I've used. I use it in combination with a short guide hose so that the coupling doesn't wear out as quickly as if it were attached directly to the air tool. Man you want to talk about the performance of them! The first one I put on was on my 1/2" impact wrench with the anvil extended by 2". It was like the wrench couldn't keep up with the air it was…

. You need to make sure your compressor can keep up. Everyone raves about how good this hardware is, but not everyone is telling the full story. The increase in torque and flow you get when using these fittings is great and I've noticed a huge difference. However, remember that you are now getting more air from your air source. This allows your compressor to work better, otherwise you will have to pause and wait longer for it to fill up! My advice is to simply change the connections on the…

Buy steel fittings if you use them daily! I work in a body shop and use a DA grinder EVERY day. Removers, DA grinders, paint guns, primer guns, etc.) I bought these to replace the old non-HVLP fittings that were on their air hoses at the store.They are made to a high standard but wear out MUCH quicker when used with pneumatic tools like grinders.At the same time I have the fittings on my tools and spray guns replaced.The one on the DA grinder has had to be replaced once but the one on my primer