Replacement Parts Kit for iRobot Roomba i3 i3+(3550), i6+(6550), i7, i7+, E5, E6 Vacuum Cleaner - Mochenli Replacement Parts Set: 2 Sets of Roller Brushes, 8 Side Brushes, 8 Filters, and 2 Tools Review

I liked the design at first, but all those long green brushes ended up breaking where they lay and spinning at the ends in the vacuum. They don't fit well and get hot. Our latest set got so hot that we actually had to replace our vacuum's connecting part through the manufacturer. Buy another brand

Great for my iRobot i7. I haven't had any issues with brush bristles or rollers being too long. But it's a lot louder than it used to be. I designed hardwood floors so that probably doesn't help. I'm sure if you had carpet the noise might not be as noticeable. But in general, the noise increases significantly. Did I use the word "noise" enough in this review?

The rollers are badly balanced. Once installed, the Rumba became very loud, like something cylindrical that wasn't balanced. And in the future the rumba will get stuck more often than when I installed other rollers. Yes I saved money but obviously no time as I've had to restore it 3 times in less than a week, got stuck under things and it's never been a problem before.

We have a large dog that has enough fur to make an Afghan blanket. To keep up with his hair loss, we have to run our Roomba E5 for 1 hour 7 days a week! The original parts have worked well for many months but have worn out over time. Bought this kit to replace worn parts. They fit and work just as well as the originals. The kit also includes a small handy tool for removing dog hair that has wrapped around the rollers and a screwdriver for replacing the side brush. I would recommend this kit to…

The brushes don't spin until I loosen the screw hard. They don't sweep up kitty litter like the original brushes, and for some reason the suction seems to be less. I'm not sure if it has less suction and I can't measure it, but it seems like there are still bits on the floor despite a full tank. I've been using the stock parts for a few weeks now and just not sure if they match the Roomba e5 parts. However, the machine still picks up a lot of pet hair, dirt, bits and debris so the parts work…

This kit seemed very valuable compared to the original parts. However, after replacing the reel bars and using them for a few weeks, I discovered a horrible fatal flaw: rubbing the accumulated dirt around the reel bars caused the swivel to heat up and actually melted the plastic of the roller bar! I had to carefully disassemble the entire assembly and cut off the melted plastic. It almost caused permanent damage to my $1,000 Roomba. See attached photos. I've been using this Roomba for over a…

My original rubber brushes are finally getting tired and it's time to replace them. One broke and I needed to replace it ASAP so I took them out to try. Yes, the machine is a little noisier than before, but the difference in cleaning is incredible. First, the original brushes ALWAYS left clumps of dog hair on the carpet when cleaning the carpets. I resigned myself to just collecting them as it seemed like a common complaint. It didn't look like a ton of lump so it didn't really matter. These…