🔧 Bushings Kit for Improved Carb Linkage Performance Review

Was part of the solution to a throttle cable problem on my 1976 Chevy C20 with a 350 engine that went from a Sharper to an Edelbrock 1406.

I installed this bushing kit on a Holley 3110 to accommodate the large hole in the carburetor linkage with the mechanical throttle linkage on my '59 GMC. The case is very high quality and made in America. I had to grind about .020 on one side of the bushing to position the linkage properly, but that's more down to my linkage setup, not the bushing. The anodized finish looks nice and should offer some corrosion resistance. Good quality item.

Was part of a solution to a throttle cable problem on my 1976 Chevy C20 with a 350 engine that went from a Spitzer to an Edelbrock 1406.

I installed this bushing kit on a Holley 3110 to accommodate the large hole in the carburetor linkage with my 59 GMC's mechanical throttle linkage. The case is very high quality and made in America. I had to grind about .020 on one side of the bushing to position the linkage properly, but that's more down to my linkage setup, not the bushing. The anodized finish looks nice and should offer some corrosion resistance. Good quality item.