🚗 Holley 4-Barrel Carburetor Chrome Gas Line Kit by Mr. Gasket (Model 1552) Review

This product is UNINTERRUPTED! Leaks in bulkhead where lines connect, leaks at both line nut flares. I HAVE NEVER PURCHASED THIS PRODUCT AGAIN! BUY GENUINE HOLLEY PARTS

Doesn't fit my Holley carburetors. Lol between the holes. I hate you, Mr. Gasket. So mad I ordered this bunch of crap. again.

This is the second thing I threw in the trash from Mr. Gasket. Couldn't get it to flow. Chinese garbage. And the nuts are 17mm as opposed to the old school 5/8. I bought another manufacturer and there were no problems.

Very well made but not for cars with a front manifold where it is on the same side as the carburettor inlets. I put this on a Ford 302 with a 4 barrel Holly. It matched the carburetor well, but extended too far forward to make a proper connection to the fuel pump. I replaced it with Holley part number HLY-34-150 which also has a built in fuel gauge connector. I recommend Holy over Mr Gasket for the design, both are of almost the same quality.

bracket for Holley 4150 (750 cfm aka 4779-9). I have never been able to attach a secondary ileum without leaking. After about the third disassembly I examined everything very carefully. It turned out that the double thread nut (which threads into the carburetor fuel tank and then gets the fuel rail packing nut) was very slightly crooked where it attached to the fuel rail nut and the packing nut was therefore easy never sits properly. I took everything to my local hot rod shop just to double…

This product is scrap! Leaks in bulkhead where lines connect, leaks at both line nut flares. I HAVE NEVER PURCHASED THIS PRODUCT AGAIN! BUY GENUINE HOLLEY PARTS

This is the second one I've thrown in the trash, Mr. Gasket. Couldn't get it to flow. Chinese garbage. And the nuts are 17mm as opposed to the old school 5/8. I bought another manufacturer and there were no problems.

Very well made but not for cars with front manifold where it sits on the same side as the carburetor inlets. I put this on a Ford 302 with a 4 barrel Holly. It matched the carburetor well, but extended too far forward to make a proper connection to the fuel pump. I replaced it with Holley part number HLY-34-150 which also has a built in fuel gauge connector. I recommend Holy over Mr Gasket for the design, both are of almost the same quality.

Attaches to Holley 4150 (750 cfm, aka 4779-9). I have never been able to attach a secondary ileum without leaking. After about the third disassembly I examined everything very carefully. It turned out that the double thread nut (which threads into the carburetor fuel tank and then gets the fuel rail packing nut) was very slightly crooked where it attached to the fuel rail nut and the packing nut was therefore easy never sits properly. I took everything to my local hot rod shop just to double…