🔒 NEIKO 10048A Security Bit Set: Premium 100-Piece Cr-V Steel Tool Kit with 1/4-inch Adapters, Phillips, Slotted, Hex, Torx Star & More - Tamperproof, Pozi, Square, Spanner, Torque, Tri-Wing, Clutch, Spline, Wing Nut – High-Performing Security Bits Review

How do you know it's the Neiko brand? The arrangement of the parts in the lid of my case is different from what is shown in the picture. The quality of the bit leaves a lot to be desired and the case is very cheap (okay, only $13 I know). There is a typo on the label. The raised labels inside are also of poor quality. No, where is the name Neiko. I've been to several carnivals and I think this is a cheap imitation, not Neiko. I guess I'll try them out, see if they hold up and update the review…

I see. This is a cheap Chinese kit similar to the ones you can buy from Harbor Freight. It's a lot cheaper than a high quality kit so you get what you pay for. However, this kit was somewhat lacking (clutch #2). I use this bit so the kit was disappointing from the start. The remaining fragments were not of the highest quality. Some of the bits wore out very quickly after moderate use. The case itself doesn't hold bits very well, so every time you open the box expect to find the right bit among…

TL;DR: Buy something else. I guess I shouldn't have expected so much but this set is absolutely not worth your money. First it arrived in a mess. The only pieces in their slots were lid pieces and a few others. I love puzzles but I didn't expect this to be one. :) Second, I think this is a used kit? There were stains on the inside of the case. Even weirder, some of the bit slots contained hot glue, presumably someone was trying to hold the bits in place. Has anyone else seen this in their kits?

You can get just about any type of bit you need with this set, but in my experience you probably won't be able to use each bit more than a few times, or possibly once before like to use it break or break. My gear stayed in my garage and was removed from my toolbox no more than four times. The first time I used the safety bit was to adjust the pressure settings on my 240 volt air compressor switch. This piece barely fit and began to undress. The second time I used this set, the tool holder…

For $15 I didn't expect an absolutely better product, but it's really cheap! IDK as they try to say it's premium. That's ridiculous! The case I got was also missing 3 bits. Had I actually received the complete set, my rating would have been closer to 3.5 stars. This box was sealed and looked well packaged but when opened there were parts everywhere. I immediately realized that I had at least one take, but no extra ones. After passing and organizing beats. I found that I was missing 1.5mm, 2.5mm