Efficient Garage Organization: NEIKO 53100A 🔧 4” Pegboard Hook Organizer Kit - 50 Pack Review

Clearly positioned as "1/4" pin. These are not 1/8 and will fit with slop in a heavily soiled 1/4 perforated plate. See attached photos, the pin on the right in both photos is an actual 1/4" pin. The clothespin on the left was sold here by this seller.

This is a TERRIBLE option for someone with a standard 1/4" hole punch. The wires are thin and the angle of the bend is such that the pins move every time you touch them. They will fall out when you remove the tool from them. save yourself from heartbreak.

Absolutely terrible design. The hooks are bent at an angle, which makes them very fragile and they easily fall off the pegboard. Sent it back and bought a better one. The attached image shows a comparison between well-designed hooks (above) and these hooks (below). This alone should show you what I just wrote.

These hooks are very fickle, I understand they don't need to be machined with high precision for what they are. However, Neiko completely misses the mark: After going through 2 boxes, I was only able to use 35 out of 100 hooks. The remaining 65 hooks were not bent enough and were therefore not attached to the pegboard (see photo). Absolutely not worth it.

These hog board hangers are either light or not heavy at best. I've included a photo showing the 6" hangers I bought for light loads versus the heavy duty commercial 1/4" hangers. Hopefully this helps show the difference between the 1/8" and 1/4" hangers. If I were to buy them again I would go with 4 inches or less due to the lightweight construction. If I buy them again I will be 4 inches or less due to the lightweight design. I hope this helps you make a wise decision.

These hooks are useless if you are trying to use them on a metal plate. The back of the hook is inclined at an angle of about 45 degrees and does not snap to latch securely onto the back of the thinner metal wall panel. They really didn't work that well with perforated chipboard. I returned them and found a few others at Revain (pegboard hooks - 50 pack of 4 inch metal pegboard hooks, pegboard hangers, zinc plated shelf hooks, pegboard organization, pegboard accessories) that have the hooks…

As mentioned earlier these are 1/8" hooks not 1/4" as advertised. This means they are NOT BAD. Not suitable for storing over, I would say over 2 pounds. Even this weight, evenly distributed along the length of the hook and not on the perforated board, will cause it to flex a lot. This completely defeats the point of longer pens. If your hole board is designed for 1/4" pins they will technically fit, but they are very unstable and will fall out if you even look at them funny. They are also…

I have about a few hundred hooks that I have purchased from many vendors over the years. After getting them and reading a few different reviews, I measured the metal diameter of the few I have. There are two main types; about 0.15 inch (like this one) and about 0.20 inch. I have a lot of both. However, they have the worst design I have ever seen. The angle on the U-shaped portion of the assembly that rests against the back of the railing holes is so small that the slightest bump or bang will…