🔧 Neutop Roller Brush Replacement for Neato Botvac Connected D3 D4 D5 D6 D7 and Botvac D Series D75 D80 D85 - Vacuum Parts and Accessories Review

Brushes are ok but poor quality filters. The holes in the filter mesh are much larger than the original Neato filters. They allow pet hair and other debris to get into the filter and clog it. The filter is only sufficient for cleaning in a household with pets. The filters are very difficult to remove and cannot be cleaned.

Haven't used roller/mixer or sweeper, only filters. I'm not disappointed but there is a noticeable difference in the quality of these filters compared to the OEM. I suspect the workaround is to swap them out more often and keep an eye on the output side to make sure the motor isn't inhaling dust particles.

Firstly, most of these reviews are for different products, not replacement brushes. Shame on Raven. And second, this brush doesn't fit right and it damaged my vacuum and I'm worried it ruined the $700 vacuum. This resulted in the part it is attached to not fitting properly and now my vacuum won't spin when I start it.

This is NOT A NEATO BRAND. It seems to fit well at first, but after trying to empty it, the part you press to release the filter doesn't work, and then you have to SUPPORT it. At some point I lost the rotating brush, it jumped out immediately. Make sure you buy from the manufacturer. Costs money! I'm also not sure if those details caused my vacuum to disconnect from my phone. Oddly enough, this happened at the same time as the filter change. DO NOT BUY.

I ordered this brush to replace my Neato Robotics Botvac D7 Connected robot vacuum. This brush is much larger in diameter than a standard brush and resists rotation in the housing. The vacuum cleaner perceives this as a brush that needs cleaning and stops working with this error. You can easily tell the difference in diameter of two brushes by holding them side by side and noting their length.

i like this video much more than stock video. I like how all of the debris moves toward the center of the brush, allowing most of the brush to remain effective as opposed to the standard brush. I don't like that they seem too short. I learned to lay the roller so that it doesn't bite off the drive's protrusion. This has already happened and I had to send my bot in for repairs. So I now route it with some copper washers and everything seems fine.