2-Piece Truck Bed Light Strip Kit - 60'' with 180 LEDs, Waterproof IP67, On/Off Switch, Blade Fuse, 2-Way Splitter Extension Cable - Ideal for Cargo, Pickup Truck, SUV, RV, Boat, and More Review

Not very bright but bright enough to get the job done. If you want super brightness, get the 12 volt cob. Guided and mounted under the edge of the truck body.

Not suitable for three sides of the bed. All cords are the same length from the switch and not long enough to reach the other side of the bed. Also, you don't need to watch tutorial videos

Bright light, easy to install. The only drawback: the cables are the same length. One side and headboard of my bed worked fine. I had to run the wires under the carpet so there would be enough wire to attach the light on the other side. Not the best design in my opinion.

It was an extra cable. I used both to get the positive cable to the battery. I connect my fuse box with a fuse box extension. I installed the ground wire to the frame. Also, there is nothing included in the package to install a switch or block where all the wires come from. Although SUPER bright. See how long the 3 meter tape lasts.

When I first installed them, I really liked them! They were easy to install (except the cords were a bit short, but I found that out), they're bright, and I love the switch option. After a few months I noticed moisture in them. I have a tonneau cover and installed it under the rails so they are protected even though they are "water proof". It does not matter. Now I'm at a point where 75% of the light isn't working anymore. Super disappointed!

Worked great for the back of my pickup. The length of the wire is narrow. I was able to start at the tail light and went under the upholstery to the other side of the bed. I could just do it like this. If you don't have a liner, you may need to splice multiple wires to increase the length for your application. I am happy with the purchase. Good built in switch and fuse. Good value for money if you have it on hand. It would give all five stars except for four due to the length of the wires.

Works great. I doubt the tape is actually 3M. The tape was red like 3M but did not include the 3M name on the tape. I bought a roll of tried and tested 3M tape and double taped it just in case. Be prepared to purchase additional cords if you decide to install a switch at the back of the bed. In order for the lamps to fit properly in a 6 foot bed, you had to install a switch in the front of the bed, which required connecting an extra power line for the switch.

The LED strips themselves are fine. But I recommend buying another product like Mictuning etc. Packaging, wiring, and even fake "M" mounting tape (compared to the tape advertised by 3M) are all signs of a poorly made, poorly designed product. I received an "updated", a longer product does not matter. As mentioned, the problem is that the length of the cable from the LED strips to the connectors and the switch is the same. There's no length to install a derailleur (and bulky hookups) on one side