🧹 Efficient Cleaning with Oreck Commercial 75202 01 Vacuum Brush Review

My original is broken. So this new one seems to be working as it should. It's been about a year and a half and it's still great

Replaced our impounded original bearing on one end better than the factory bearing. Perfect fit, five minute install. Thanks very much!

Oreck XL is difficult to move on carpeted floors. I replaced the worn out brush with this one, thinking I'll use a different vacuum. This is the same product that costs three times as much on Oreck's website. Highly recommended, don't buy a new vacuum, buy a new brush. Installation is easy, unscrew the 5 screws from the bottom, remove the brush strap and put on a new one. A ten minute job if you decide to clean the bottom of the unit when you change brushes.

My commercial Oreck had a problem with it being difficult to slide over carpet. YouTube Help. Nuts wear out the whisk, so over time the vacuum cleaner's nozzle comes into contact with the carpet and increases the resistance to the vacuum's pulling/pushing. I was surprised at how easy the Oreck was to maintain. Even an idiot like me can watch YouTube videos and service every part of this vacuum cleaner. I compared my new whisk to the original factory handle - I couldn't tell them apart except…

Oreck Commercial 75202-01 Oreck vacuum brush purchased June 2018: Fits perfectly and works well 5 times I've used it within about 20 minutes. every time. BUT the bearing on the side of the belt drive WILL NOT melt the black plastic end plate that attaches and supports it, rendering the entire brush useless. This failed because long hairs became tangled in the gap between the drive side plate and the roller brush, overheating the bearing to the point of freezing, twisting in the plastic housing…

I have had Oreck vacuums for many years and have given them to my children at home. This vacuum brush is the best of the two models they sell. This is for a standard vacuum cleaner. A standard brush is simply better than a normal one. It has a metal end roller, metal bearings, upgraded brushes and two-way height adjustment at the ends of the roller. You adjust the brush to the height setting for the new one, and when it wears out you can adjust the setting to a second position that brings the…