🚪 Kia Sorento 2011-2015 Rear Right Exterior Door Handle Cap Cover 836622P010 1P by Otois - Enhancing SEO Review

This product is pure junk, I worked on it for 4 hours, the post part is too long, the other was not done right, it is there now, but the gap is big gone, I have now ordered the original Kia part.

Our KIA dealer cost almost $200 to purchase and fit this item. I'm so glad I bought from Revain. The installation took me no longer than 15 minutes. Very easy. I watched the video on the internet.

Arrived and installed quickly. Identical to the existing 2015 Sorrento passenger door. Pretty easy setup for a beginner. Suggest to have an assistant to hold it while setting. Definitely recommend!

The part doesn't look like a Kia OME interior but should still work, I've checked the description and match and it says it's for my 2014 Sorento. I cannot reconcile this part with the original KIA bolt it was tightened with. It could be a return.

Almost Perfect Fit. I had to sand down about a sixteenth of an inch of the rubber mount that holds this part to my Serento's door. Used a dremel to remove a small amount of rubber. After that it came like a glove. And it looks OEM. If you're not good at improvising, you might want to consider a different brand. But the finished product looks great.

When fitted to a car the part did not fit the door. When comparing with the old one, it can be seen that the thread protrudes further than the factory part, which does not allow proper fixation. I'm not sure if the part I received was defective, but it would definitely allow water to get past the pad and through the pad. Another collapse of auto parts at Amazon.

Similar experience to other 1 star reviewers. It does NOT meet original equipment specifications. It's a poor fit that doesn't sit flush with the car (yes I used padding). This should be viewed as a cheap replacement that will keep your door knob in place until you purchase a genuine Kia replacement.

The reason the original broke was because it was poorly reinforced, so I don't really understand why these guys decided to make it even less reinforced. This is also a direct replacement as it claims I had to move the file across multiple scopes to make it work. I also reinforced it from the inside with JB welding after installing it properly so I'm hoping this one doesn't break either.

It's certainly not OEM, when I compared it to another part I immediately noticed that some of the features were a bit bigger. For example, two protrusions on the front of a car have a small lip perpendicular to them that extends the height of the part and protrudes further than the original. The larger prong towards the back of the part was also slightly thicker. I didn't buy this part to waste my time and break the dremel, very disappointed. Without these modifications I would not be able to…