Header banner
Revain logoHome Page
enhance precision work with oudtinx lathes degree point center logo

Enhance Precision Work with Oudtinx Lathes Degree Point Center Review

3

·

Average

Revainrating 3 out of 5  
Rating 
3.0
🪚 Industrial Drill Bits, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(3)
img 1 attached to Enhance Precision Work with Oudtinx Lathes Degree Point Center
img 2 attached to Enhance Precision Work with Oudtinx Lathes Degree Point Center
img 3 attached to Enhance Precision Work with Oudtinx Lathes Degree Point Center

Description of Enhance Precision Work with Oudtinx Lathes Degree Point Center

MT5 Carbide Tipped Dead Center. Morse Taper 5; Hardened And Ground. Runout: .00039''. 60 Degree Point; Overall Length: 7-7/8'' Long. Quantity: 1; Unit Weight: 4 Lbs *Estimate Only*; Unit Overall Dimension: 1-3/8''L x 1-3/8''W x 7-7/8''H *Estimate Only*.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

Good product, good quality

Good dead center. I especially like the carbide tip, at least until I dropped it and smashed the carbide all over the shop. Very good product, good quality.

Pros
  • Runout: 0.00039'
Cons
  • Expensive

Revainrating 3 out of 5

Porosity in the solder joint

Purchased MT2 and MT3. Mt2 is ok but mt3 has a lot of pores in the solder joint. They were cheap so didn't expect much. Let's see how long they last.

Pros
  • MT5 with carbide tips
Cons
  • Long delivery time

Revainrating 1 out of 5

Defective and out of specification

Upon unpacking the dead center, an apparent defect was found where the tip was soldered to the main body. However, since I had to use deadlock for some work, I was willing to ignore the error. There was also a noticeable wobble when setting a dead center in the spindle on a lathe and rotating the tip. The dial gauge shows a runout of 0.005 inches, well above the advertised spec of 0.00039 inches. Resetting the spindle dead center to 180 degrees and retesting confirmed that the hit was due to…

Pros
  • 60 degrees; Overall Length: 7-7/8'
Cons
  • No Instructions