Partsam 5-Pack Waterproof Red Rectangular Double Bubble Bullseye LED Side Marker Clearance Lights, featuring 10 Diodes for Surface Mount on RVs, Trucks, Campers, ORVs, ATVs, and Motorcycles Review

I crashed my motorhome into an obstacle and broke the red lens. They were the same size and shape, standard, but the lens wasn't interchangeable, but it was so easy to swap out the entire unit that there were no issues.

These headlights look good, they're quite bright and there was just enough of them for my camper van taillights. Very satisfied! Hope they last long. The manufacturer has been around for a long time.

I bought a couple of these last year to rewire our horse trailer and only ordered them as spares as horses tend to eat/break them . The lights work great, they are bright and easy to install, good quality and low price.

Neat product. I installed them on my caravan and the only problem I have is the cable exit point. I removed the LED board from the light base, drilled a new hole back in the middle, rerouted the wire and used glue to attach the LED board back to the light base. Headlights work as they should, no problems.

Parts do not have the expected number of LEDs. This makes it impossible to fit in a dedicated application as a replacement, among other things. The LED fill was bad. It wasn't installed to see color balance and lighting, but when installed on one side on a long trailer the differences might not be noticeable. But it will meet the requirements of the law "

These LED position lights are great for their price. They are bright and work well. Since the wiring is offset towards the end rather than centre, as mentioned, I would assume that this limits the likelihood of water getting into the unit. Another pitfall and the main reason I'm not giving 5 stars is the lenses, which don't have a built-in reflector. So if your state requires reflectors like the one on the back you will need to add an independent reflector or reflective tape like I did with you

I bought these to replace the parking lights on my van. At first glance they appear well made and bright. A serious design flaw was discovered while attempting to install these lights. The holes where my RV wiring harness goes through the wall should be centered behind the parking light. The problem with these lights is that the wires come out of the mounting plate at one of the corners. If you try to route the wires behind the mounting plate to the existing holes on my RV, the headlights won't