Header banner
Revain logoHome Page
pointzero inline lubricator with regulator filter logo

PointZero Inline Lubricator with Regulator Filter Review

3

·

Very good

Revainrating 4 out of 5  
Rating 
4.0
💨 Compressed Air Treatment, ⚙️ Filtration

View on AmazonView on ЯM

Media

(4)
img 1 attached to PointZero Inline Lubricator with Regulator Filter
img 2 attached to PointZero Inline Lubricator with Regulator Filter
img 3 attached to PointZero Inline Lubricator with Regulator Filter
img 4 attached to PointZero Inline Lubricator with Regulator Filter

Description of PointZero Inline Lubricator with Regulator Filter

Set is wall mountable for convenient installation. Regulator removes water and other contaminants from the airflow. Lubricator unit is designed to release measured amounts of oil into the airflow. Protects and lubricates all connected tools.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Another installed and working, great value

Bought 2 of these. Came on time. One came with missing parts. The other is operational and excellent value for money. The sensor was a bit tricky to install, but my locksmith managed it. No problem sending another one back. Thanks again for your help.

Pros
  • Wall mount kit for easy installation
Cons
  • Available in white only

Revainrating 3 out of 5

Minor problem with pressure gauge

There is actually a small problem with the correct seating of the pressure gauge as case screws on the back panel prevent it from being tightened sufficiently. No doubt a more knowledgeable person could find an extension that would make this seat the right one. There were no problems with the return of the money because this product did not fully meet my requirements. I recommend this seller as it is easy to work with.

Pros
  • Lubricator to dispense a measured amount of oil into the air stream
Cons
  • Ugly packaging

Revainrating 4 out of 5

Yes; BSP 1/4 " for filters, regulators and lubricator

Just installed this setup today. After reading some of the other comments I was concerned but it worked fine. I have 1/4" NTP with teflon tape around the male threads of the fittings which i installed and tightened on the inlet and outlet of the regulator. Checked with soapy water, no leaks. As for the pressure gauge of the regulator. It rests on the body of the regulator. So I held the jig with the male threads pointing to the right, I made 6 turns clockwise with the teflon tape and it fits…

Pros
  • Protects and lubricates all attached instruments
Cons
  • No power