🔧 PrimoChill 1/2in. Clear Rigid PETG Tube, 30in. Length, Pack of 6 Review

I bought these about a month ago and before reviewing them I wanted them to work on my system for a while. Now that they are installed along with the Primochill pipe and 90 degree swivel fitting I have to say all the components are great and I have not had any issues with them. They're affordable, unbranded, and look great on my system.

Wrong inner diameter in different retail packaging. The build could not be completed correctly due to this issue. I had 2 separate retail packs and 1 of them was the perfect ID because the tube bender fitted perfectly. The other was too tight on the inside and gave nothing but flexing issues as the insert couldn't go in and ripped the insert. Inconsistencies in a manufacturing defect. Just be careful guys.

OVER AND OVER TIME! Pros: - Heats up in seconds and can be bent - Soaked tube insert slides in and out perfectly without bubbling Cons: - I cleaned my setup twice to find the ends were melted and twisted, luckily not leaking (temp mine is low)

Did my first cycle with this. Paired with PrimoChill 1/2". The RevolverSX series rigid fittings worked great. Make a second loop and use the same YouTube: customgtpPC names: Project: XEON and Project: HTPCAlso Zombie Hunter (I used Barrow 12mm for this one)

Oh my god! I've finally found the perfect material for my magic fountains! I wish there was a way to upload a video to show you. Unfortunately, the picture does not convey this. This is a great see through finned tube that I melt and roll. I will order many more!

This material has been used in several designs. Always looks great and is easy to handle compared to other hard tubes. I will only use this in the builds I am doing now. Definitely use a Primochill revolver with it.

Will not work I purchased these tubes to use with these fittings: https://www.amazon.com/EKWB-EK-HDC-Compression-Fitting-Tube /dp /B0779N1SRH/ref=sr_1_5?keywords=EK-HDC+Fitting+G1%2F4&qid=1554215901&s=gateway&sr=8-5А Pipes did not fit because they were 1mm wider than the fitting. I tried sanding the end of the pipe and that didn't work either, and aesthetically it looked TERRIBLE. Also try this silicone: https://www.amazon.com/gp/product/B01LWY6BR5/ref=ppx_yo_dt_b_asin_title_o06_s00…

These were purchased for the patio fountain. They are the right size and easily trimmed with large pruning shears without tearing.

Rigid means it won't bend. That's my definition. I wanted to use it to keep the illusion with the transparent tube and unfortunately it bends. If it's rigid like the label says then what word am I looking for if the tube is really rigid hmm?