🔧 QualGear QG-PRO-PM-VCA-B Sloped Ceiling Adapter: Ideal Pro-AV Accessory for 1.5" Npt Threaded Pipe Projectors Review

Had to be installed on a large building with joists at non standard angles and all 4 setups worked great and the options for this mount were successful at every angle.

This is a sturdy and high quality bracket. In fact, I was surprised they didn't sell them twice as expensive as they did. I used them to assemble the camera mounts. They hold a 10 foot long rigid pipe securely in place. I will buy them again soon!

Industrial strength and versatility. The lock nuts helped keep the yaw center slightly off-center (about 3 degrees). Used in conjunction with the QualGear ProAV mount

This mount is solid and well built. In fact, I was surprised they didn't sell them twice as expensive as they did. I used them to assemble the camera mounts. They hold a 10 foot long rigid pipe securely in place. I will buy them again soon!

I bought this to mount an Epson 99WH projector to an overhead light grid in a TV studio. The description said it would fit up to 3" diameter pipe or truss and I would install it on 1-3/4" pipe. I was concerned that I wouldn't be able to tighten the adapter enough to stop it from moving down the pipe, but that's not a problem. There are two small V notches that keep the tube centered for a tight fit. I had no problem connecting a 1.5" NPT pipe to the adapter. In general, an excellent solution.