🔧 Ravinte Cabinet Door and Drawer Hardware Template Kit with Included Drill Bit for Easy Installation Review

Drawer Knobs and Pulls Purchased from RevainBasics, used this product to measure kitchen cabinets and drawers with beveled corners. It is very easy to use and saved a lot of time.

My wife and I used these to install pulls and cup handles on drawers and cabinets. It worked very well and only took a few hours to work. Very happy with this product.

Good for fitting handles to drawers but cabinet door template does not fit properly (see image). There is no hole for installing poles even near the middle. Very disappointed that I now have to purchase another product to get the job done properly.

Glad we ordered this template for our gear. He did a good job of aligning the holes to the correct width, but the depth was a little off so some of our buttons came out slightly crooked. It could also be user error. I would still get the template when installing hardware. It definitely made it easier and, for the most part, consistent.

Whilst this template is good for new cabinets it is almost useless when used on cabinets with replacement hardware that require the use of an existing hole! The hole you have may or may not match the template (as in our case). The template is good for an empty cabinet or drawer, but a waste of money if used on a cabinet door or drawer with existing holes. Will be returning it to Revain for a refund!

I work on repairing kitchen cabinets. The finishes are different on each side (one with handles, one without), so I wanted to make sure I had consistency and ease when drilling holes. It worked well and I was surprised at how quickly I drilled new hardware holes. In hindsight, it was so easy because this product took the guesswork out of the process. I just used a double knife to make a small mark where the pilot holes would go and bam! Did! The included drill bit was also pretty good and…

I decided to take a chance and buy an inexpensive version of the cabinet/door handles ($1.36 each) and decided to buy an extra jig because I knew it would be easier. Now they're well spaced on the template, but it didn't line up with the center of my doors. It's okay because it was close enough that you couldn't see it. The drawer template was very easy to use, with a notch at the top to line up my center and the door template has guides to line it up with the corner of the door. The included…