🎮 OSTENT Nintendo DS Lite NDSL Full Replacement Housing Shell Case Kit - Color: Black Review

This product seems cheap, it might be the one I received but one of the screw holes was cracked when I received it and the case didn't close properly.

One of the biggest complaints I have with these aftermarket skins is that the screw holes don't line up properly. I don't know if it was just a defect in my shell, but I've ordered several of these over the years and found this to be the problem. Another major issue is that the holes inside the case for the ribbon cables and buttons are poorly cut or perforated. I usually find excess plastic that I have to remove with a small razor before proceeding with the restoration. It was the same with…

All the parts were included in the kit and I would have ignored the poor quality screens and the odd bubbles on top of the plastic case if the mold hadn't been made not done right. Parts entering the left and right sides of the middle loop stop earlier than they should and do not fully enter. Also, when trying to insert the left side, the kit would not enter the right side of the left loop, but when pressure was applied, it would enter the right side of the right loop (as shown in the picture…

I bought two of these for me and my girlfriend. when put on the bottom it doesn't fit like the original, and after putting on the back both ds lites stopped charging completely. I can't find out what he did to the motherboard but both only stopped charging after this part was fitted, I have new motherboards and I used the original bottoms. There may be some color deviation, but at least it works. I did mine first and was worried why it stopped charging so I repeatedly checked charging on my…

This was very disappointing. While the case looks good on the outside, there are numerous measurement issues, including two so severe that I had to redesign the case to make the power button fit (actually, I gave up and didn't even include it because it didn't work). ). close) the part you want the switch to slide into doesn't let it slide at all, not even a little. Even after modifying it with a soldering iron I couldn't get it to work. Worst? buttons at the shoulders. God, I've been trying to