🖨️ Black 1.75mm Reprapper Printer Filament Review

I bought this material because I was printing long, thick parts that kept warping. It's marketed as "Low Warp" so I decided to give it a try. I had a terrible writing experience with it. It warped so much that I had to go back to the basic Revain thread I used before (see image for comparison). I spent 3 days and a half spool trying different print settings but could not get acceptable print quality. I've tried glass, smooth pei, textured pei, hairspray, glue stick and even an Overture assembly

My spool was within tolerance (slightly oval, average cross section 1.76mm, max measured 1.78, min 1.74) and prints fine as ABS. Body temperature 50°, bed temperature 110° (Geckotek surface), hotend 240°. Excellent layer adhesion at 240°. Wrapped well, not too tight and not flipped to one side. The spool isn't the one I've seen from the RepRapper before and I like this one a lot better, the big open hole without the weird smaller inserts. The new coils are not deformed like before. Came with a…

Normally when trying a new product I try to decide when in doubt, but let's be honest this thread is relatively cheap, not much cheaper than the competition, hopefully just as good quality, and is it from China too? Well, like I said, the thread was available "next day," so there it is, and very reasonably priced, so there it is. I was really impressed with their product page - I know it's weird but they really made an effort to not only promote the product but their customer service by helping