🖨 Revolutionary OPTO Washable Printing Photopolymer Non Clear Additive Manufacturing Products Review

I have actually tried quite a few resins. It is as strong as ABS-like and does not become brittle when cured. The part can be easily cleaned with a little cold soapy water and then rinsed with cold water. Besides, it doesn't stink. I print cases for electronics. projects. Most resins, unless initially brittle, will compress enough to deform the case. Not this one. I have a Black II. It works just as well as $40 ABS and is only $25 a gallon. You'll also save money by not having to purchase…

For now I've been using Rich-Opto Translucent Orange, Black and White. This white is simply unprintable. I was very fortunate to be able to use basically the same orange and black print settings. They have a lot of great prints, but the White-II is terrible. Most prints don't adhere to the buildplate, but I've also had many issues with prints where some of the prints fail, why printing with supports doesn't print fully, or the print pulls itself without the buildplate (again or poor adhesion)…

Really good product. I said this for the same exposure time as any standard cubic gray. I use it on mono x. I've had a lot of problems with each cubic monox, just bad prints that won't stick and some weird warping. I did all that and applied some teflon grease and all and that obviously helped a lot. But those rich optics don't quite deliver precise detail, which is okay. Prints really accurate. Very little deformation of any. Supports are easily removed. The only thing I noticed is that I put…