🚗 Black Pismire License Plate Bracket: Roller Fairlead Mount Holder for Improved SEO Review

Delivered quickly, well packaged. It was exactly what I wanted and expected. The only downside to this is that a couple of screws on the surface of the board are preventing my board that I added from sitting flush. It has a "bent" appearance due to the protruding studs that prevent it from sitting flush.

Good build quality, snaps onto my reel key and holds tight. But the screws holding the rail clips stick out where the license plate is, and the holes for attaching the license plate to the bracket don't match the holes in my license plate. It's close enough to work, but it could be better.

Easy to install on a Warren winch. Problem 1: The license plate mounting points were about 1/16 closer than the license plate holes would allow. A few taps with the rat's tail on the plate file fixed it. Problem 2, The clip mounting screws were in the way of the license plate. I added four 1/4" flat washers between the plate and bracket at each mounting screw. This created clearance so the plate would not deform due to screws protruding from the clamps. Although not mentioned in the…

This product serves its intended purpose as a bracket/holder for a front license plate that snaps onto the winch idler. I bought it for my Warn Evo VR10 installed on my Jeep Wrangler JKU and it looks ok. Here are a few things to know so you don't get frustrated with your under $20 purchase: 1. The license plate won't sit flush because the clamp bolts/nuts are sticking out. Loosen them and turn the screw so that you slide it through the other side and reinstall the nut. This way the plate will…