🚤 SEO-Optimized: Seachoice 28510 Marine Boat Steering Wheel - Universal UV-Resistant 4-Spoke Review

Not used yet, but screwed on immediately. The photos and reviews got me thinking, so I'll add a few. If I change my feelings I will update this later. I had to add my old badge from the original steering wheel.

There are no complaints about this bike. What is this, an inexpensive way to replace the steering wheel that meets all the requirements? Easy to install, good value for money and very durable. I will add that it looks good on the boat. Thanks very much!

If I knew the texture of this wheel I would buy another one. This wheel is exactly what it says so I can't fault the wheel. However, it seems very cheap and I don't think I'll be leaving it for long. It should have more grip.

Ok for the price. It is NOT rich leather with stitching, it is hard plastic and the center cap is not included. In the middle is a hard plastic part without emblems. Had I known they were hard plastic I would have looked at some other wheels that cost less than $30.

Decent steering wheel for the price. Fits as expected, easy assembly. Mine has a small seam line around the wheel that had to be removed from the inside and outside edges to make them smooth. The steering wheel is molded from hard plastic. The middle cover is thin and can be easily removed for assembly. Overall it's not too bad, I just didn't like the thin paper cuts I got from poor cleaning during the casting process.

I've spent a few hours looking for boat steering wheels on Amazon and elsewhere. Few could match the price of this sports steering wheel, and none of them could match the style. The entire faceplate comes off to reveal a hex nut that attaches the wheel to the steering rack. It took a lot of WD 40 and effort to get the old handlebar off, but it stuck in clean and tidy. Don't expect sports car wheel quality but it was a definite upgrade for my ski boot.

. Works great. Installed in moments. It has a round indentation on the hubcap that has my tracker logo taped onto it from an old steering wheel and it fits perfectly. After 21 years, the original steering wheel melted off. Sprayed some WD-40 on the front of the spline shaft and on the shaft behind the steering wheel and waited 5 minutes. I gave the mother a couple of light taps with a hammer and the steering wheel fell off slightly. A layer of dialect grease was applied to the slotted shaft for