Throttle Handle Grips and Grip Cable Set for Mini Baja Mb165 Mb200 5.5 6.5hp 196 200cc Doodlebug Bike - 50 Inch Length Review

Looks and works fine but the end of the cable had to be cut off to go through the mounting grommet And there isn't enough cable hanging over the outer skin so the skin had to be cut off to do this the raw edge on the liner and cable end

Good quality, everything works well. I had to refine the device, but I expected it, and you should too for all the different applications you might use it for. I used it on a 200cc Baja mini bike. The grips were less gnarly and aggressive than the originals but didn't compromise.

I liked the product but the cable was too short for a 24" tricycle. I used an aluminum choke with handle and cable from another, works great. I had to use rim tape under the handle mount to keep the knot from twisting when the handle was twisted, in this case it works fine.

Does not fit Baja MB 165 Throttle with 6.5hp engine. Need a throttle cable threaded at each end of the cable, not just the handlebar end. I had to go to another provider and pay $19 for the exact cable. It is also recommended to use a cordless drill and drill to deburr or smooth the inside of the throttle cable retainer to avoid chafing/wearing out the new cable.

So the order was placed and still not shipped after a week so I tried to cancel the order. I order a similar choke from another company that fits my needs, not Signwise but a more expensive one and I paid $8 shipping. We seem to be all you have to do is try to cancel your order and voila it will be shipped the same day. I received it and wanted to send it back and use a more expensive choke. Well the more expensive choke was a total failure so I went back to Signwise. Well it fits my MB200…

Well it turned out good. I used bits and pieces from my old throttle body to get it right. The actual cable cover is too long. In the end, not enough cable sticks out. I used my old cable cover with a new cable. The throttle body will not fit the Doodlebugs handlebar. I think you could drum them a bit to fix that. I used my old accommodation. The handles are perfect for doodles. The old ones went in the garbage. Straight screw, no it's not. But if you have old parts, you can get the job done…