Header banner
Revain logoHome Page
enhanced filament detection for sunhokey printer: revolutionizing additive manufacturing logo

Enhanced Filament Detection for Sunhokey Printer: Revolutionizing Additive Manufacturing Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Enhanced Filament Detection for Sunhokey Printer: Revolutionizing Additive Manufacturing
img 2 attached to Enhanced Filament Detection for Sunhokey Printer: Revolutionizing Additive Manufacturing
img 3 attached to Enhanced Filament Detection for Sunhokey Printer: Revolutionizing Additive Manufacturing
img 4 attached to Enhanced Filament Detection for Sunhokey Printer: Revolutionizing Additive Manufacturing

Description of Enhanced Filament Detection for Sunhokey Printer: Revolutionizing Additive Manufacturing

Filament Detection Module - Newly designed smart module, The main board executes the pause command operation when the filament is run out. Main Function -for checking the filament is whether run out or not, it automatically stops the 3D Printer when the filament runs out. Extended Product Life - A wear-resistant copper sleeve is added to the feed port and the discharge port at the same time can effectively prolong the service life of the product. 3D Printer Accessories-Very practical filament detection sensor module, ideal accessories for 3D printer, making your printing work smooth and relieved.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Works as intended. - 3D Printing Consumables

I needed to change the connectors for my SKR v1.3 board. I just used white sensor wire and ground. After that everything went great.

Pros
  • 3D Printing Consumables
Cons
  • Wrinkled

Revainrating 5 out of 5

Simple and efficient

Works great. Just use the digital input pin, the +5V pin and the GND pin. If you are using Marlin, you must set up the correct pins in the pins_*.h file for your board. I don't know of any other firmware packages.

Pros
  • Industrial and scientific
Cons
  • Uncertain

Revainrating 3 out of 5

Is working. Could be better.

I use it with a Robo3D printer and it really helps to pause the print when the filament runs out. It requires a mounting base or bracket as it simply hangs between the spool and printhead. Also, the wire hanging from above seems out of place; It would fit better on the side. I was expecting it to be more or less just an addition, but the signal cable had to be swapped out afterwards to match the RAMPS board. Other brands work better.

Pros
  • Additive Manufacturing Products
Cons
  • Doubt