Sunjoyco Rocker Waterproof Switches Vehicles Review

Good switch set. Worked well for wiring in our new dive lights on our boat. I wish they weren't saying lite up all the time, but we haven't noticed any battery drain yet.

Finally installed this panel last month. A switch broke for the first time in a boat. The second time the second switch fell apart. The back flew off and the feathers fell out. I DO NOT RECOMMEND.

Was easy to connect and use but the decals make it very difficult to tell which ones I need as they are clear, the switch lights stay on until you get the battery unhook, so I don't want to drain my battery if it's not used for some time so it is.

I am not very happy with this product as it feels detached before I can use it. Just by unplugging the wiring the switch contacts fell out, the switches didn't stick to the mounting plate and the normal stickers that came with it.

The product fell apart a week after installation. Worked great the day I installed it on my boat and then when the boat sat in the driveway for a week I went to show someone how all the lights work and three of the four switches didn't work . You didn't even click! I looked at the switches and the backs literally fell off and the springs fell out. The tabs are also broken. I hope to return!

It is very practical. Each switch is pre-wired, all you need to do is connect power and ground to the device and all switches are ready to use. Simply connect the power side to the switch you intend to use and ground it to any good earth source you like. The only thing I want is the master switch to kill or activate the party. I used mine to control the water tank heaters in my caravan. It would be nice to only toggle on/off for the whole group.

The pins on each of the switches are of the lowest quality. Several were broken out of the box. The only use of this part would be if you want to use it according to the setup because as soon as you want to remove one of the quick connects look at the empty hole where the pin should be. If you can use them as is, i.e. you already connect the hot wire to the switching power supply, they will work fine. In fact, there's no moisture protection, just a rubber grommet on the back of the mount.

Good, looks good. Nice aluminum plate. Two lighted switches are cool. Use either one, both, or neither. I don't like it when the wiring is pre-wired. The wiring is not only too small for the switch rating, but also for the accessories used since it all changes together. The wires are coming off the switch blades like hell, pulling the blades out. Luckily the blades can be reused, but still. I removed the switches from the panel and after reinstalling some of them are very loose.